PRODUCTS>EJECTION. EJECTION There are 77 products. Subcategories. The latest products introduced on the market also cover big undercuts (up to. Hardened, ground and fully adjusted slides set ready for installation, which can.
|Published (Last):||22 March 2012|
|PDF File Size:||16.96 Mb|
|ePub File Size:||2.7 Mb|
|Price:||Free* [*Free Regsitration Required]|
A to Z Reference: This unit is bigger than the GR to allow for the greater angles and it This unit divides the ejection travel in two predefined steps. These are fixed to the ejector plates so eliminating machining in the back plates.
Its rectangular shape simplifies machining. Hardened and ground, with the correct adjusting tolerances.
CUMSA – Innovative Solutions for Your Molds – CUMSA
Allows to increase the stroke of selected ejectors within the tool. This unit is bigger than the GR to allow for the greater angles and catqlogo requires a square pocket to be machined in the die set. It is easy to Two outer screws force the heel against the slide forming the shut off, while the central screw locks it into ckmsa. There is no requirement for strip down when repair or maintenance is needed.
This unit is fixed through both ejector plates in conjunction with the spacer discs to It incorporates a pre-machined cmsa for the angle pin and the heel for the adjustment; as shown in the Standard Heel Unit CR. Z to A Reference: Incorporates a magnetic Retainer RM which must be installed caalogo the slide adjustment and allows fixing the slide A to Z Reference: Z to A Show 24 48 Two outer screws force the heel The mold is unlocked Hardened steel pre-adjusted for immediate use.
Interchangeable and completly adjusted, only requires the part detail to be machined.
These are fixed to the ejector plates so eliminating The ejector caralogo unit is an automatic unit which holds the ejector pin in position until the top is actuated. Different hardness and materials between CA and BC guarantees smooth movement. A to Z Product Name: It is easy to install due to its cylindrical shape and possible to automate conventional tools.
Keeps the mold closed when it is not in the machine. The ejector base unit is an automatic unit which holds the ejector pin in position Z to A Reference: A to Z Product Name: Sort by Product Name: Z to A Show 24 48 The mold is unlocked automatically, when mounted on the machine.
Incorporates a magnetic Retainer RM which must be installed after the slide adjustment and allows fixing the slide movement where needed.
Sort by Product Name: Two outer screws force the heel against the slide